Foxconn D42S 3.0 Manuel d'utilisateur télécharger pdf (Page 18)

Front Panel Connector : FP1

This motherboard includes one connector for connecting the

front panel switch and LED Indicators.

Hard Disk LED Connector (HDD-LED)

Connect to the chassis front panel IDE indicator LED. It

indicates the active status of the hard disks. This 2-pin

connector is directional with +/- sign.

Reset Switch (RESET-SW)

Attach the connector to the Reset switch on the front

panel of the case; the system will restart when the switch

is pressed.

Power LED Connector (PWR-LED)

Connect to the power LED indicator on the front panel of

the chassis. The Power LED indicates the system’s status.

When the system is in operation (S0 status), the LED is

on. When the system gets into sleep mode (S1) , the LED

is blinking; When the system is in S3/S4 sleep state or

power off mode (S5), the LED is off. This 2-pin connector

is directional with +/- sign.

Power Switch Connector (PWR-SW)

Connect to the power button on the front panel of the

chassis. Push this switch allows the system to be turned

on and off rather than using the power supply button.

Serial ATA Connectors : SATA_1/2

The Serial ATA connector is used to connect with SATA Hard

Disk or CD devices which supporting this feature. The current

Serial ATA II interface allows up to 300MB/s data transfer

rate.

IrDA Connector : IR/CIR1

This connector supports infrared wireless transmitting and

receiving device.

EMPTY

HDD-LED

RESET-SW

PWR-SW

PWR-LED

FP1

SATA _1/2

GND

TX+

TX-

GND

RX-

RX+

GND

IR/CIR1

+5V

EMPTY

IRRX

GND

IRTX

+5VSB

CIRRX

GND

CIRTX

EMPTY

1 2

9 10

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 42 43

Commentaires sur ces manuels

Pas de commentaire

Foxconn D42S 3.0 Manuel d'utilisateur Page 18

Commentaires sur ces manuels

Produits connexes et manuels pour Carte mère Foxconn D42S 3.0